Table of Contents
Advertisement
Figure 13: Connecting the Grounding Cable
6.
Connect Power to an AC-Powered Services Gateway
WARNING: The device must be properly grounded before you connect the AC power
cords.
1.
2.
3.
NOTE: Each power supply must be connected to a dedicated AC power feed and a
dedicated external circuit breaker. We recommend that you use a 15 A (250 VAC)
minimum, or as permitted by local code.
Verify that the grounding cabling is correct, that it does not touch or block access
to device components, and that it does not drape where people could trip on it.
Attach an electrostatic discharge (ESD) grounding strap to your bare wrist and
connect the strap to one of the ESD points on the chassis. For more information
about ESD, see the SRX 3400 Services Gateway Hardware Guide.
Locate the power cord or cords you will use to connect the device to AC power.
See the SRX 3400 Services Gateway Hardware Guide for specifications.
For each power supply:
Insert the appliance coupler end of the power cord into the appliance inlet
a.
on the power supply.
Insert the power cord plug into an external AC power source receptacle.
b.
Step 5: Connect the Ground and Power Cables
Step 5: Connect the Ground and Power Cables
15
Advertisement
Table of Contents
