Alarm Relay Contact Wire Specifications For The Srx5400 Services - Juniper SRX5400 Hardware Manual

Related
Documentation
Routing Engine Interface Cable and Wire Specifications for the SRX5400 Services Gateway
Related
Documentation
Alarm Relay Contact Wire Specifications for the SRX5400 Services Gateway
Copyright © 2014, Juniper Networks, Inc.
Appendix D: Cable and Wire Guidelines and Specifications for the SRX5400 Services Gateway
P = 5.5 dB
M
In both examples, the calculated power margin is greater than zero, indicating that the
link has sufficient power for transmission and does not exceed the maximum receiver
input power.
Signal Loss in Multimode and Single-Mode Fiber-Optic Cable for the SRX5400 Services
Gateway on page 203
Attenuation and Dispersion in Fiber-Optic Cable for the SRX5400 Services Gateway
on page 204
Calculating Power Budget for Fiber-Optic Cable for the SRX5400 Services Gateway
on page 205
Table 36 on page 207 lists the specifications for the cables that connect to management
ports and the wires that connect to the alarm relay contacts.
Table 36: Cable and Wire Specifications for Routing Engine Management
and Alarm Interfaces
Cable
Port Specification
Routing Engine RS-232 (EIA-232)
console or serial cable
auxiliary
interface
Routing Engine Category 5 cable or
Ethernet equivalent suitable
interface for 100Base-T
operation
Connecting the SRX5400 Services Gateway to a Network for Out-of-Band Management
on page 58
Connecting the SRX5400 Services Gateway to a Management Console or an Auxiliary
Device on page 59
Table 37 on page 208 lists the specifications for the wires that connect to the alarm relay
contacts.
Cable/Wire Maximum
Supplied Length
One 6-ft (1.83-m) 6 ft
length with (1.83 m)
RJ-45/DB-9
connectors
One 15-ft (4.57-m) 328 ft
length with (100 m)
RJ-45/RJ-45
connectors
Routing
Engine
Receptacle
RJ-45 female
RJ-45
autosensing
207