Configuring Junos Os For The Srx5400 Services Gateway; Srx5400 Services Gateway Software Configuration Overview - Juniper SRX5400 Hardware Manual

CHAPTER 10
Configuring Junos OS for the SRX5400
Services Gateway

SRX5400 Services Gateway Software Configuration Overview

Related
Documentation
Copyright © 2014, Juniper Networks, Inc.
SRX5400 Services Gateway Software Configuration Overview on page 73
Initially Configuring the SRX5400 Services Gateway on page 74
The services gateway is shipped with the Junos operating system (Junos OS) preinstalled
and ready to be configured when the device is powered on. There are three copies of the
software: one on a CompactFlash card (if installed) in the Routing Engine, one on the
hard disk in the Routing Engine, and one on a USB flash drive that can be inserted into
the slot in the Routing Engine faceplate.
When the device boots, it first attempts to start the image on the USB flash drive. If a
USB flash drive is not inserted into the Routing Engine or the attempt otherwise fails, the
device next tries the CompactFlash card (if installed), and finally the hard disk.
You configure the services gateway by issuing Junos OS command-line interface (CLI)
commands, either on a console device attached to the
Engine, or over a telnet connection to a network connected to the
Routing Engine.
Gather the following information before configuring the device:
Name the device will use on the network
Domain name the device will use
IP address and prefix length information for the Ethernet interface
IP address of a default router
IP address of a DNS server
Password for the root user
Initially Configuring the SRX5400 Services Gateway on page 74
port on the Routing
CONSOLE
ETHERNET port on the
73