Installing The Srx5400 Services Gateway Air Filter - Juniper SRX5400 Hardware Manual

Installing the SRX5400 Services Gateway Air Filter

Copyright © 2014, Juniper Networks, Inc.
pull small bits of wire or other materials into the device through the unfiltered
air intake. This could damage the services gateway components.
To remove the air filter (see
Attach an electrostatic discharge (ESD) grounding strap to your bare wrist, and connect
1.
the strap to one of the ESD points on the chassis.
Loosen the captive screws on the air filter cover.
2.
Remove the air filter cover.
3.
Slide the air filter out of the chassis.
4.
Figure 40: Removing the Air Filter
To install the air filter (see
Attach an electrostatic discharge (ESD) grounding strap to your bare wrist, and connect
1.
the strap to one of the ESD points on the chassis.
Locate the up arrow and ensure that the air filter is right side up.
2.
Slide the air filter straight into the chassis until it stops.
3.
Align the captive screws of the air filter cover with the mounting holes on the chassis.
4.
Tighten the captive screws on the air filter cover.
5.
Chapter 13: Replacing SRX5400 Services Gateway Hardware Components
Figure 40 on page 111):
Figure 41 on page 112):
111