Reinstalling the Fan Tray After Installing the SRX5400 Services Gateway Without a Lift
Copyright © 2014, Juniper Networks, Inc.
Appendix F: Installing the SRX5400 Services Gateway Without a Mechanical Lift
Figure 75: Reinstalling a Power Supply
To reinstall the fan tray (see
Attach an electrostatic discharge (ESD) grounding strap to your bare wrist, and connect
1.
the strap to one of the ESD points on the chassis.
Grasp the fan tray on each side and insert it straight into the chassis. Note the correct
2.
orientation by the "this side up" label on the top surface of the fan tray.
Tighten the captive screws on the fan tray faceplate to secure it in the chassis.
3.
Figure 76: Reinstalling the Fan Tray
Figure 76 on page
219):
219