Juniper SRX5400 Hardware Manual page 128

SRX5400 Services Gateway Hardware Guide
114
Removing the SRX5400 Services Gateway SCB
To remove the SCB (see Figure 42 on page
NOTE: The SCB and Routing Engine are removed as a unit. You can also
remove the Routing Engine separately.
CAUTION: Before removing the SCB, ensure that you know how to operate
the ejector handles properly to avoid damage to the equipment.
Power off the device.
1.
Place an electrostatic bag or antistatic mat on a flat, stable surface.
2.
Attach an electrostatic discharge (ESD) grounding strap to your bare wrist, and connect
3.
the strap to one of the ESD points on the chassis.
Rotate the ejector handles simultaneously counterclockwise to unseat the SCB.
4.
Grasp the ejector handles and slide the SCB about halfway out of the chassis.
5.
Place one hand underneath the SCB to support it and slide it completely out of the
6.
chassis.
Place the SCB on the antistatic mat.
7.
If you are not replacing the SCB now, install a blank panel over the empty slot.
8.
Figure 42: Removing the SCB
Installing an SRX5400 Services Gateway SCB
To install the SCB (see Figure 43 on page
114):
115):
Copyright © 2014, Juniper Networks, Inc.