Example Xmodem Configuration Upload Using Hyperterminal; Figure 337 Menu 24.7.2 As Seen Using The Console Port; Figure 338 Example Xmodem Upload - ZyXEL Communications ZyWall 35 User Manual

Figure 337 Menu 24.7.2 As Seen Using the Console Port

Menu 24.7.2 - System Maintenance - Upload System Configuration File
To upload system configuration file:
1. Enter "y" at the prompt below to go into debug mode.
2. Enter "atlc" after "Enter Debug Mode" message.
3. Wait for "Starting XMODEM upload" message before activating
Xmodem upload on your terminal.
4. After successful firmware upload, enter "atgo" to restart
the system.
Warning:
1. Proceeding with the upload will erase the current configuration file.
2. The system's console port speed (Menu 24.2.2) may change when it is
restarted; please adjust your terminal's speed accordingly. The password
may change (menu 23), also.
3. When uploading the DEFAULT configuration file, the console port speed
will be reset to 9600 bps and the password to "1234".
2 After the "Starting Xmodem upload" message appears, activate the Xmodem protocol on
your computer. Follow the procedure as shown previously for the HyperTerminal
program. The procedure for other serial communications programs should be similar.
3 Enter "atgo" to restart the ZyWALL.

40.5.11 Example Xmodem Configuration Upload Using HyperTerminal

Click Transfer, then Send File to display the following screen.

Figure 338 Example Xmodem Upload

After the configuration upload process has completed, restart the ZyWALL by entering
"atgo".
Chapter 40 Firmware and Configuration File Maintenance
Do You Wish To Proceed:(Y/N)
ZyWALL 35 User's Guide
535