Using The Ftp Command From The Dos Prompt; Figure 10-7 Telnet Into Menu 24.7.2 - System Maintenance - ZyXEL Communications ZyWALL 10 User Manual

ZyWALL 10 Internet Security Gateway
Menu 24.7.2 - System Maintenance - Upload Router Configuration File
To upload the router configuration file, follow the procedure below:
1. Launch the FTP client on your workstation.
2. Type "open" and the IP address of your router. Then type "root" and
SMT password as requested.
3. Type "put configurationfilename rom-0" where "configurationfilename"
is the name of your router configuration file on your workstation,
which will be transferred to the "rom-0" file on the router.
4. The system reboots automatically after the upload router configuration
file process is complete.
For details on FTP commands, please consult the documentation of your FTP
client program. For details on uploading router firmware using TFTP (note
that you must remain on this menu to upload router firmware using TFTP),
please see your router manual.

Figure 10-7 Telnet into Menu 24.7.2 - System Maintenance

To transfer the firmware and the configuration file, follow these examples:

10.6.1 Using the FTP command from the DOS Prompt

Step 1.
Launch the FTP client on your workstation.
Step 2. Type open and the IP address of your ZyWALL.
Step 3.
You may press the [ENTER] when prompted for a username.
Step 4. Type root and your SMT password as requested. The default is 1234.
Step 5.
Type bin to set transfer mode to binary.
Step 6. Use "put" to transfer files from the workstation to the ZyWALL, e.g., put zywall.bin ras
transfers the firmware on your computer (zywall.bin) to the ZyWALL and renames it "ras".
Similarly put zywall.rom rom-0 transfers the configuration file on your computer
(zywall.rom) to the ZyWALL and renames it "rom-0". See section 10.1 for more information on
filename conventions.
Step 7.
Type quit to exit the ftp prompt.
10-8
Press ENTER to Exit:
Transferring Files