Figure 279 15.2.1.2: Nat Server Configuration; Table 182 15.2.1.2: Nat Server Configuration - ZyXEL Communications ZyWall 35 User Manual

Figure 279 15.2.1.2: NAT Server Configuration

The following table describes the fields in this screen.

Table 182 15.2.1.2: NAT Server Configuration

FIELD
WAN
Index
Name
Active
Start Port
End Port
IP Address
When you have completed this menu, press [ENTER] at the prompt "Press ENTER to Confirm..." to
save your configuration, or press [ESC] at any time to cancel.
5 Enter a port number in the Start Port field. To forward only one port, enter it again in the
End Port field. To specify a range of ports, enter the last port to be forwarded in the End
Port field.
6 Enter the inside IP address of the server in the IP Address field. In the following figure,
you have a computer acting as an FTP, Telnet and SMTP server (ports 21, 23 and 25) at
192.168.1.33.
7 Press [ENTER] at the "Press ENTER to confirm ..." prompt to save your configuration
after you define all the servers or press [ESC] at any time to cancel.
Chapter 34 Network Address Translation (NAT)
15.2.1.1 - NAT Server Configuration
Wan= 1
------------------------------------------------
Name= 1
Active= Yes
Start port= 21
IP Address= 192.168.1.33
Press ENTER to Confirm or ESC to Cancel:
DESCRIPTION
The ZyWALL has two WAN ports. You can configure port forwarding and trigger port
rules for the first WAN port and separate sets of rules for the second WAN port.
This is the WAN port (server set) you select in menu 15.2.
This is the index number of an individual port forwarding server entry.
Enter a name to identify this port-forwarding rule.
Press [SPACE BAR] and then [ENTER] to select Yes to enable the NAT server entry.
Enter a port number in the Start Port field. To forward only one port, enter it again in
the End Port field. To specify a range of ports, enter the last port to be forwarded in
the End Port field.
Enter the inside IP address of the server.
ZyWALL 35 User's Guide
Index= 1
End port= 25
477