CR Reader, CR Advanced Reader, CR Multiformat Reader | Introduction to CR Reader,
Image Acquisition Software
The digitizer can be used in combination with software for image acquisition,
identification, image processing and image transmission of digitized images
received from the digitizer. This manual uses examples for a combination with
the NX workstation.
To install the UPS into the system
To install the UPS into the system:
1. Plug the UPS power cord into the input connector at the UPS rear panel.
2. Plug the other side of the UPS power cord into a power outlet.
3. Plug the digitizer, NX workstation and monitor into the appropriate UPS
output receptacles.
In case of power failure, the batteries of the UPS supply power to the
digitizer, the NX workstation and monitor.
Full Leg Full Spine Application Components
• CR Full Body Cassette Holder
• Anti-scatter grid (optional)
• CR EasyLift
For more information and instructions on the FLFS application, refer to the
document 4408, "CR Full Leg Full Spine User Manual".
CR Advanced Reader and CR Multiformat Reader | 13
TM
(optional)
2591D EN 20191028 1712