52 | DX-D 100 | Getting started
Displacement and positioning workflow
Topics:
•
Driving the unit
•
Releasing the arm
•
Positioning the unit
•
Positioning the X-ray tube and collimator
Driving the unit
1. Grip and hold the locking bar towards the handlebar.
1.
2.
2. Push the handlebar with both hands to drive forwards.
Apply different pressure on the left and the right to steer the unit.
3. Release the locking bar to block motion.
Releasing the arm
1. Press the brake control at the tube-collimator handles to release the arm
from parking position.
2. Press and hold the brake control while using the handles to rotate the
column and move the arm horizontally and vertically.
0187K EN 20191024 1609
CAUTION:
Before using DX-D 100, check the battery levels on the control
panel. If the red indicator is blinking, operation is not allowed.
In that case, it is necessary to charge the batteries.
Note: If you use a wired network the network cable must be
unplugged to be able to perform this step.
Locking bar
Handlebar
1
2