Mazda CX-9 Grand Touring 2009 Manual page 1014

2008 ENGINE PERFORMANCE On-Board Diagnostic (MZI-3.7) - Mazda CX-9
HAS BEEN RECORDED
1
Has FREEZE FRAME DATA
been recorded?
VERIFY RELATED REPAIR
INFORMATION AVAILABILITY
Verify related Service Bulletins
2
and/or on-line repair information
availability.
Is any related Service Bulletins
available?
INSPECT VEHICLE OPERATION
Check for:
Water, ice, mud and snow
causing wheel slippage.
Excessive engine speed in
3
N (Neutral).
Check whether the vehicle
way driven at a high rate of
speed.
Was the vehicle driven under any
of the above conditions?
VERIFY TROUBLESHOOTING OF
DTC P0297 HAS BEEN
COMPLETED
Verify that all disconnected
connectors are reconnected.
Turn the ignition switch to the
ON position (Engine off).
4
Clear the DTC from the PCM
memory using the M-MDS.
Start the engine and run it at idle.
Retrieve DTCs using the M-
MDS.
Is the PENDING CODE for this
DTC present?
VERIFY AFTER REPAIR
PROCEDURE
5
Perform "AFTER REPAIR
PROCEDURE". (See AFTER
2008 Mazda CX-9 Grand Touring
Record FREEZE FRAME DATA on the repair order,
No
Perform repair or diagnosis according to the available
Service Bulletins.
Yes
If the vehicle is not repaired, go to the next
step.
No
Yes Vehicle is normal. Then go to the next step.
Clear DTCs and refer to "DIAGNOSTIC INDEX "
No if customer had any drive ability concerns. (See
QUICK DIAGNOSTIC CHART [MZI-3.7] .)
Replace PCM, then go to the next step. (See PCM
Yes
REMOVAL/INSTALLATION [MZI-3.7] .)
No
Go to the applicable DTC inspection. (See DTC
Yes
TABLE [MZI-3.7].)
then go to the next step.
Go to the next step.
Go to the next step.