TROUBLESHOOTING
PRINTING IS NOT POSSIBLE OR STOPS DURING A JOB
Point to check
Is a tray out of paper?
Is the machine out of toner?
Has a paper misfeed occurred?
Is the output tray full?
Is the waste toner box full?
Are restrictions placed on the trays that can
be used in each mode (copy, print, fax,
Internet fax, and document filing)?
Index
Solution
Add paper as instructed by the
message in the touch panel.
Replace the toner cartridge.
When toner runs low, a message will appear
to inform you that the toner cartridge must be
replaced.
For more information on replacing the toner
cartridge, see "REPLACING THE TONER
CARTRIDGE".
Remove the misfeed as instructed by
the message in the touch panel.
- "REMOVING MISFEEDS" in
"TROUBLESHOOTING"
Remove the output from the tray and
resume printing.
When the output tray becomes full, a detector
activates and stops printing.
Replace the waste toner box as
instructed by the message in the
touch panel.
- "REPLACING THE WASTE TONER BOX"
Check the settings in [Paper Tray
Settings] and see if checkmarks
appear in the checkboxes of each
mode ([Feeding Approved Job]).
Functions without a checkmark cannot be
used for printing using that tray.
"Setting mode" → [Paper Tray Settings] →
[Tray Registration] → [Feeding Approved Job]
Contents
MX-2610N / MX-3110N / MX-3610N