Sharp MX-3610N User Manual page 1164

This setting determines the paper selection condition when printing received faxes. Select one
of the three conditions below.
Print Actual Size Cut off Disabled
The received fax image is printed at full size without dividing it onto multiple sheets of paper. If
the same size of paper or larger paper is not loaded, the fax will be received in memory and
will not be printed until a suitable size of paper is loaded.
However, if the received fax is longer than A3 (11" x 17") size, it will be automatically divided
onto multiple sheets of paper.
Print Actual Size Cut off Enabled
Each received image is printed at full size. If necessary, the image is divided onto multiple
sheets of paper.
Auto Size Select
Each received image is printed at full size when possible. When not possible, the image is
automatically reduced before printing.
Set the Telephone Number for Data Forwarding
When a problem prevents the machine from printing a received fax, the received fax can be
forwarded to another fax machine. This setting is used to program the fax number of the
destination fax machine. Only one forwarding fax number can be programmed (maximum of 64
digits).
To insert a pause between digits of the number, tap the [-] key.
If you wish to specify an F-code confidential memory box in the destination machine, tap the [/]
key after entering the fax number and enter the F-code (sub-address and passcode).
Letter Size RX Reduce Print
This program is not available in Canada and Philippines.
When a letter (8-1/2" x 11") size fax is received, this setting reduces the fax to A4 size.
When this setting is enabled, A4 size faxes are also reduced.
Receiving Date & Time Print
Enable this setting to have the date and time of reception printed.
Select [Inside the Received Image] or [Outside the Received Image] for the position where the
date and time is printed.
When [Inside the Received Image] is selected, the date and time of reception is printed on the
received image.
When [Outside the Received Image] is selected, the received image is reduced and the date
and time of reception is printed in the blank area that results.
The [Outside the Received Image] cannot be selected for the reception date and
time print setting if "Auto Receive Reduce Setting" is not enabled.
A3 RX Reduce