Sharp MX-3610N User Manual page 1097

User Name: Enter the user name for POP before SMTP communication.
Password: Enter the password required for POP before SMTP communication. To change
the password, set [Change Password] to
Enable SSL: If set to
communication by STLS command is enabled.
This requires the server to support the POP over SSL communication or the STLS
command.
To allow SSL communication, set the "Port Number" to the POP over SSL communication
port number.
To allow POP over TLS communication, set the "Port Number" to the same port number
as for the normal POP3 communication.
Connection Test
Tap the [Execute] button to test the connection to the SMTP server.
SNMP
SNMPv1 Settings
SNMP v1 Settings
Set this option to use the SNMPv1 settings.
Access Method
Set an access method.
GET Community
Enter the GET community name to fetch the device information using SNMP.
SET Community
Enter the SET community name required for SNMP setting.
Change SET Community
To change the SET community, set
TRAP Community
Enter the community name to be used for the SNMP TRAP sent from the device.
TRAP Target Address
Enter the IP address of the destination computer for SNMP TRAP communication.
SNMP v3 Settings
SNMP v3 Settings
Set this option to use the SNMPv3 settings.
User Name
Enter the user name.
Authentication Key
.
, the POP over SSL communication or the POP over TLS
.