Sharp MX-3610N User Manual page 1042

Erase Width Adjustment
This is used to set the default erase width for erase function. Specify a value from 0 mm (0") to
25 mm (1") in increments of 3 mm (1/8") for both edge erase and centre erase.
Card Shot Settings
This is used to set the default original size for the card shot function.
Specify a value from 25 mm (1") to 216 mm (8-1/2") in increments of 3 mm (1/8") for both the
X (horizontal) and Y (vertical) dimensions of the original.
Fit to Page
Enable this setting to have the [Fit to Page] key always appear in the card shot screen.
Automatic Saddle Stitch
Saddle stitch stapling take place automatically when the pamphlet copy function is used.
Initial Tab Copy Setting
This is used to set the default image shift width (tab width) for tab copying.
Specify a value from 0 mm (0") to 25 mm (1") in increments of 3 mm (1/8").
Prohibition of Program Registration
This is used to prohibit the deletion and changing of copy settings stored in job programs.
Disabling of Bypass-Tray in Duplex Copy
Disables the use of the bypass tray when making 2-sided copies.
The bypass tray is often used to feed label sheets, transparency film, and other special media
for which 2-sided copying is prohibited. If a sheet of one of these special media enters the
reversing unit, a misfeed or damage to the unit may result. If special media for which 2-sided
copying is prohibited is often used, it is recommended that you enable this setting.
Disabling of Auto Paper Selection
Disables the Auto Paper Selection function.
When this setting is enabled, automatic selection of paper that is the same size as the original
on the document glass or in the automatic document feeder does not take place.
Auto Selection Setting of Tray that is Supplied the
Paper