Sharp MX-3610N User Manual page 1092

IPv6
Enable this setting.
DHCPv6
Use this setting to have the IP address obtained automatically using DHCP (Dynamic Host
Configuration Protocol) v6. When this setting is enabled, it is not necessary to manually enter
an IP address.
Manual Address/Prefix Length
Enter the IP address and the prefix length (0 to 128) of the machine.
Default Gateway
Default Gateway
If DHCPv6 is used, the IP address assigned to the machine may change
automatically. If the IP address changes, printing will not be possible.
If the machine is used on a TCP/IP network, be sure to enable the "Enable
TCP/IP" below.
In an IPv6 environment, the machine can use LPD or IPP protocol.
Ping Command
Checks if the machine can communicate with the PC of the network.
Specify the IP address of the desired PC and tap the [Execute] key. A message indicating a
response by the PC or not is displayed.
NetWare
NetWare Settings
NetWare
To use the machine on a NetWare network, this setting must be enabled.
Frame Type
Select a frame type.
Settings: 802.2, 802.3, SNAP, ETHER-II
Operation Mode
Select an operation mode.
Settings: PSERVER, RPRINTER
Printer Name
Enter the printer name.
PSERVER Settings
Print Server Name