Sharp MX-3610N User Manual page 1052

*
400 X 400 dpi , 600 X 600 dpi
Fax
Normal and small characters
* Half Tone
Apply the Resolution Set when Stored
When an image stored by document filing is used, this applies the resolution setting that was
stored with the image.
Default Exposure Settings
This is used to set the default exposure settings for scanning a document in image send mode.
Select [Auto] or [Manual]. If you select [Manual], set the exposure to one of 5 levels.
Default Original Image Type
Select the original type beforehand to enable scanning at a resolution suitable for the original
(only in scan mode and USB memory device scan mode).
The following settings can be configured.
Text/Printed Photo
Text/Photo
Text
Photo
Printed Photo
Map
When the exposure is set to [Auto], a default original type cannot be selected.
Sharpness
This is used to emphasize the outline of image and show it clearly for scanning a document in
image send mode. It can be set to any of 5 levels.
Contrast
This is used to adjust the contrast of image for scanning a document in image send mode. It
can be set to any of 5 levels.
Send the same image that has been sent via Fax/Internet Fax.
This is used to enable or disable the default setting. Enable this function to send the same
image simultaneously using fax mode or Internet fax mode with another mode. If this function
is disabled, an image specified with each Scan Setting is sent to E-mail, FTP, Desktop, and
Network Folder.
Must Input Next Address Key at Broadcast Setting
This function forces the user to tap the [Next Address] key before entering the next destination
during broadcasting.
When this setting is enabled, the [Next Address] key cannot be omitted even if the next
*
* * *
, Fine , Ultra Fine