Sharp MX-3610N User Manual page 1188

TROUBLESHOOTING
AUTO SELECTION OF THE COLOUR MODE DOES NOT TAKE
PLACE CORRECTLY
If you are unable to solve a problem using the solutions in this manual, press the [Power]
button and then turn the main power switch to the "
then turn the main power switch to the "
changes from orange to green, press the [POWER] button.
When the background colour of the job status display at the upper right corner of
the touch panel is not grey, do not switch off the main power switch or unplug the
power plug. This may damage the hard drive or cause the data being stored or
received to be lost.
Point to check
Are you scanning one of the following types
of originals?
When Black & White is not selected:
Are there colours or colouring in the
paper?
When Colour is not selected:
Is the colour in the original very light?
Is the colour in the original very dark,
almost black?
Is only a very small area of the original
coloured?
Index
"position. Wait at least 10 seconds and
"position. After the main power indicator colour
Solution
When the colour mode is set to "Auto", the
machine detects whether the original is black
and white or colour when the [Colour Start]
key is tapped. However, when an original of a
type as shown on the left is used, automatic
detection may not give the correct result.
In this event, specify the colour mode
manually.
Contents
MX-2610N / MX-3110N / MX-3610N