Sharp MX-3610N User Manual page 1181

TROUBLESHOOTING
FINISHER
8
< steps in all >
Open the cover.
While pressing the lever
over to the left, slide the
finisher to the left until it
stops.
Gently slide the finisher until it stops.
Lower the staple case
release lever and remove
the staple case.
Pull the staple case out to the right.
Raise the lever at the front
end of the staple case and
remove the jammed staple.
Remove the leading staple if it is bent. If
bent staples remain, a staple jam will
occur again.
Take care that a bent staple does not hurt you.
MX-2610N / MX-3110N / MX-3610N