Sharp MX-3610N User Manual page 1198

Are you using a printer port created using
Standard TCP/IP Port?
(Windows 2000/XP/Server 2003/Vista/Server
2008/7)
Is "Connect via" set to [Ethernet] for
AppleTalk?
(Mac OS 9.0-9.2.2)
Is your computer in an unstable state?
Is the machine specified correctly in the
application that you are using for printing?
Are the network connection devices operating
normally?
Is the I/O timeout setting too short?
Was a Notice Page printed?
be assigned to the machine.
"Setting mode" → [Network Settings]
Check the PC settings.
When a port created with Standard TCP/IP
Port in Windows is used and the [SNMP
Status Enabled] checkbox is
possible to print correctly. Change the [SNMP
Status Enabled] checkbox to
See: Software Setup Guide
Open [AppleTalk] from the [Control
Panels] and make sure that
[Ethernet] is selected in the "Connect
via" menu.
Printing is not possible if [Ethernet] is not
selected.
Restart your computer.
Printing is sometimes not possible when you
run multiple applications at once or there is
insufficient memory or hard drive space.
Restart your computer.
Check whether the machine's printer
driver has been selected from the
print window of the application.
If the machine's printer driver does not appear
in the list of available printer drivers, it may
not be installed correctly. Remove the printer
driver and then install it once again.
See: Software Setup Guide
Make sure that the routers and other
network connection devices are
operating correctly.
If a device is not powered on or is in an error
state, see the manual of the device to correct
the problem.
Check with your administrator.
If the I/O timeout setting is too short, errors
may occur while writing to the printer. Ask the
administrator of the machine to configure an
appropriate time in "I/O Timeout".
"Setting mode" → [Printer Settings] →
[Interface Settings] → [I/O Timeout].
Check the Notice Page.
A Notice Page will be printed to indicate the
, it may not be
.