TROUBLESHOOTING
SADDLE FINISHER
Finisher unit
< 8 steps in all >
Open the front cover.
While pulling the lever,
slide the saddle finisher to
the left until it stops.
Lower the staple case
release lever and remove
the staple case.
Pull the staple case out to the right.
Raise the lever at the front
end of the staple case and
remove the jammed staple.
Remove the leading staple if it is bent. If
bent staples remain, a staple jam will
occur again.
Take care that a bent
staple does not hurt you.
MX-2610N / MX-3110N / MX-3610N