Sharp MX-3610N User Manual page 1215

Does a message appear indicating that the
memory is full?
Does a message appear notifying you that the
original size was not detected?
Does the job status screen (completed jobs)
or a transaction report indicate that the
transmission was not successful?
Did you place a long original on the document
glass when it is scanned?
the transmission is temporarily cancelled and
then automatically re-attempted after a brief
interval.
"Setting mode" → [System Settings] → [Image
Send Settings] → [Fax Settings] → [Send
Settings] → [Recall in Case of Communication
Error].
To cancel the transmission, tap the job status
display on the operation panel, tap the key of
the print job that you wish to delete, and tap
the [Stop/Delete] key. A message will appear
to confirm the cancellation. Tap the [Cancel]
key.
The machine supports error correction mode
(ECM) and is configured to automatically
resend any part of a fax that is distorted due
to noise on the line.
"Setting mode" → [System Settings] → [Image
Send Settings] → [Fax Settings] → [Default
Settings] → [ECM]
Divide the originals into sets and fax
each set separately, or use direct
transmission.
If the memory becomes full, the transmission
will be cancelled.
Place the original again. If the original
size is still not detected correctly, specify the
original size manually.
Perform the transmission again.
If the transmission is still not successful after
recalling is performed as set in [Recall in
Case of Line Busy] or [Recall in Case of
Communication Error], the transmission failure
will be indicated in the job status screen and
the transaction report.
"Setting mode" → [System Settings] → [Image
Send Settings] → [Fax Settings] → [Send
Settings] → [Recall in Case of Line Busy]
"Setting Mode" → [System Settings] → [Image
Send Settings] → [Fax Settings] → [Send
Settings] → [Recall in Case of Communication
Error]
Place the original in the document
feeder tray of the automatic
document feeder.