Sharp MX-3610N User Manual page 1096

SMTP Settings
Primary Server
Enter the IP address or the host name of the primary SMTP server.
Secondary Server
Enter the IP address or the host name of the secondary SMTP server.
Port Number
Enter a port number. The default setting is port 25.
Timeout
Enter a timeout. The default setting is 20 seconds. This value is used for connection to the
SMTP server and for data transmission according to the e-mail system specifications.
Source Address
If data transmission has failed, the undelivered e-mail may be returned from the server.
Enter an e-mail address (a single address only) to receive such undelivered mails.
Usually, enter the e-mail address of system administrator.
Enable SSL
If the SSL is enabled, the SMTP-over-TLS encryption communication can be used by
STARTTLS command.
This requires the server to support the STARTTLS command.
To allow SSL communication, set the "Port Number" to the same port number as the normal
SMTP.
SMTP Authentication
Carries out the SMTP server authentication.
If you use the Kerberos authentication, set the KDC server, port number, and realm on the
Kerberos authentication settings page.
User Name
Enter the user name.
Password
Enter the password.
To change the password, set [Change Password] to
POP before SMTP
If is set, you are authenticated to the POP server before using the SMTP communication.
POP3 Server: Enter the IP address or the host name of the secondary SMTP server.
Port Number: Enter the POP3 port number for POP before SMTP communication. The
default setting is port 110.
POP Authentication: If
authentication to the POP3 server.
is set, the authentication protocol (including APOP) is used for
.