Sharp MX-3610N User Manual page 1037

configure the port number and IP address of the machine used as the tandem slave machine.
Disabling of Master Machine Mode
To prohibit tandem transmission, enable this setting. (Normally this setting is not necessary.)
Disabling of Slave Machine Mode
To prohibit tandem reception, enable this setting. (Normally this setting is not necessary.)
To use the tandem function when user authentication is enabled, the same login
name and password must be used on both the master machine and slave machine.
If the same login name and password are not used, the page count may not be
added to the appropriate user count or only the master machine may print.
The factory default setting for the port number is [50001]. Unless you experience
difficulty with this setting, do not change the port number.
Detect Standard in Auto Colour Mode
When the colour mode is set to auto in copy mode, the discrimination point for detecting
whether originals are colour or black and white can be set to one of 5 levels. When set to
[Closer to B/W], the originals are easier to recognize as black and white. When set to [Closer
colour], the originals are easier to recognize as black and white.
Fusing Control Settings
These are used to control the toner fusing temperature according to the weight of the paper.
These settings apply to plain paper, recycled paper, punched paper, pre-printed paper,
letterhead paper, coloured paper, and user type paper.
You can select "60g/m
Be sure to use only paper that is in the same weight range as the weight range
set here. Do not mix plain or other paper that is outside the range with the paper
in the tray.
When settings are changed, the changes will take effect after the machine is
restarted. To restart the machine, see "TURNING ON THE POWER" in
"BEFORE USING THE MACHINE"
Index
2 2
to 89g/m " or "90g/m
Contents
2 2
to 105g/m " ("16 to 23 lbs." or "23+ to 28 lbs.").