Sharp MX-3610N User Manual page 1053

address is entered with a one-touch key.
If a user attempts to enter the next address without tapping the [Next Address] key, a double-
beep alarm will sound and the entry will be rejected.
Scan Complete Sound Setting
Sets the scan complete sound to be heard when an original is scanned.
Disable Switching of Display Order
Disables to change the order of display (search number order, ascending, descending).
Once set, the display sequence is not changed. The display order will remain fixed at the order
that is in effect when this setting is enabled.
Hold Setting for Received Data Print
This function holds received faxes and Internet faxes in memory without printing them. The
faxes can be printed by entering a password (factory default setting: 0000) with the numeric
keys.
Password
When [Hold Setting for Received Data Print] is enabled, enter the password (4-digit number).
These settings can only be configured when there is no received data in the
machine memory (excluding data in a confidential or relay broadcast memory box).
Default Verification Stamp
This is used to enable or disable the default setting. Enable this to always affix the verification
stamp on the original that has already been scanned using the automatic document feeder.
Erase Width Adjustment
This is used to set the default erase width for erase function. Specify a value from 0 mm (0") to
25 mm (1") in increments of 3 mm (1/8") for both edge erase and centre erase.
Time Specified Output of Received Data
This function is available when the Received Data Image Check Setting is enabled.
ENABLE/DISABLE SETTINGS
Settings to Disable Registration
This is used to prohibit the storing of destinations. Storing from the machine, storing from
Setting mode (Web version), and storing from the PC can each be separately prohibited.
Disable Registering Destination from Operation Panel
Disables address control from the machine.
Configure the setting for each of the following items:
Group (Direct Entry)