Sharp MX-3610N User Manual page 1091

SETTING MODE
PROTOCOL SETTINGS
Select the general network settings.
The TCP/IP, NetWare, EtherTalk, and NetBEUI status information can be set.
TCP/IP
TCP/IP Settings
TCP/IP
To use the machine on a TCP/IP network, this setting must be enabled.
IPv4 Settings
When using the machine on a TCP/IP (IPv4) network, use this setting to configure the IP
address of the machine.
DHCP/BOOTP
Use this setting to have the IP address obtained automatically using DHCP (Dynamic Host
Configuration Protocol)/BOOTP (Bootstrap Protocol). When this setting is enabled, it is not
necessary to manually enter an IP address.
If DHCP/BOOTP is used, the IP address assigned to the machine may change
automatically. If the IP address changes, printing will not be possible.
If the machine is used on a TCP/IP network, be sure to enable the "Enable TCP/IP"
below.
RARP
Set this option to use the RARP protocol.
IPv4 Address
Enter the IP address of the machine.
Subnet Mask
Enter the IP subnet mask.
Default Gateway
Enter the default gateway address.
IPv6 Settings
When using the machine on a TCP/IP (IPv6) network, use this setting to configure the IP
address of the machine.
MX-2610N / MX-3110N / MX-3610N