Sharp MX-3610N User Manual page 1159

When a transaction report is printed, this is used to print part of the first page of the transmitted
original on the transaction report. For details, see "Original Print on Transaction Report".
When transaction report printing is set for "Receiving", a report will not be printed
for a reception from a number specified as a reject number in "Allow/Reject
Number Setting".
Activity Report Print Select Setting
This is used to have the Image Sending Activity Report that is stored in the machine memory
printed at regular intervals.
The Image Sending Activity Report can be set to print each time the number of transactions
reaches 200, or at a specified time (once a day only). (The settings can be simultaneously
enabled.)
If you only select the "Print Daily at Designated Time" setting
of recorded transactions reaches 200 before the specified time, each new
transaction will delete the oldest transaction (the oldest transaction will not be
printed).
The Transaction Report can be printed out manually as needed. For more
information, see "LIST PRINT (ADMINISTRATOR)".
ECM
Line conditions can sometimes distort a transmitted fax image. When ECM (Error Correction
Mode) is turned on, pages that are distorted are automatically re-transmitted.
If the other machine supports Super G3, ECM will function regardless of this
setting.
Distinctive Ring Detection
This Setting can only be activated in Canada, Australia, New Zealand, and Hong Kong.
If multiple telephone numbers have been assigned to your telephone line, the number called
can be identified by its ringing pattern. By using one number for voice calls and another
number for faxes, you can tell which type of call you are receiving by the ringing pattern. You
can set your machine to automatically receive faxes when your fax number is called by setting
the pattern that corresponds to your fax number. (Note that in Canada, six selections are
available.)
PBX Setting
This Setting can only be activated in France and Germany.
When the machine is used on a PBX, you can enable the PBX setting to have the machine
automatically connect to the outside line. When this setting is enabled, the [R] key appears in
the base screen. When the [R] key is tapped, the PBX setting is temporarily cancelled.
If your PBX uses the Flash method to connect to the outside line, select the [Flash]. If your
PBX uses an ID number to connect to the outside line, specify the ID number.
and the number