Cp1W-Da041 Analog Output Settings - Omron CP1L-EL20DR-D Operation Manual

Inverter Positioning
CP1W-DA041 Analog
Output Settings
■
Internal Work Addresses
Address
D1010
D1011
D1020
T0
■
Settings Addresses
Address
D102
CIO 100.02
CIO 100.03
Analog output 1 is used in this example. It is set to a range of 4 to 20 mA. The
scaled value is set in the analog conversion area of the Analog Output Unit.
P_First_Cycle
First Cycle
Flag
T0
Refer to the first line in the programming example in Referencing the Auto-
matically Calculated Inverter Frequency Command Value on page 370 for a
timer for the time required for the Analog Output Unit's data to be valid (ana-
log conversion trigger: T0).
■ Internal Work Addresses
Address
D102
T0
■
Settings Addresses
Address
CIO 102
CIO 103
Holds the frequency command value converted for the analog
output resolution.
Holds the frequency command value converted from 0.01-Hz
increments to hertz.
Analog conversion trigger
Bits 00 to 15: Analog output value
Forward (external output)
Reverse (external output)
Bits 00 to 15: Analog output value
Analog conversion trigger
Bits 00 to 15: Analog conversion area
Bits 00 to 15: Analog conversion area
Section 7-3
Usage
Usage
Analog output 1 set to a
MOV
range of 0 to 20 mA
#800B (range code: B hex).
Analog outputs 2 to 4 are
102
not used.
D103 (scaled value) is
MOV
initialized.
#0000
103
MOV
D102 (scaled value) is
initialized.
#0000
D102
MOV
The scaled value in
D102 is written as the
D102
converted data for
102
analog output 1.
Usage
Usage
371