Omron CP1L-EL20DR-D Operation Manual page 739

Auxiliary Area Allocations by Address
Address Name
Words Bits
A276 All Pulse Output
and 0 PV
A277
A278 All Pulse Output
and 1 PV
A279
A280 00 Pulse Output
0 Accel/Decel
Flag
01 Pulse Output
0 Overflow/
Underflow
Flag
Function
Contain the number of pulses output
from the corresponding pulse output
port.
PV range: 8000 0000 to 7FFF FFFF
hex
(-2,147,483,648 to 2,147,483,647)
When pulses are being output in the
CW direction, the PV is incremented
by 1 for each pulse.
When pulses are being output in the
CCW direction, the PV is decre-
mented by 1 for each pulse.
PV after overflow: 7FFF FFFF hex
PV after underflow: 8000 0000 hex
A277 contains the leftmost 4 digits
and A276 contains the rightmost 4
digits of the pulse output 0 PV.
A279 contains the leftmost 4 digits
and A278 contains the rightmost 4
digits of the pulse output 1 PV.
Cleared when operation starts.
Note If the coordinate system is
relative coordinates (unde-
fined origin), the PV will be
cleared to 0 when a pulse
output starts, i.e. when a
pulse output instruction
(SPED(885), ACC(888), or
PLS2(887)) is executed.
This flag will be ON when pulses are
being output from pulse output 0
according to an ACC(888) or
PLS2(887) instruction and the output
frequency is being changed in steps
(accelerating or decelerating).
Cleared when operation starts or
stops.
OFF: Constant speed
ON: Accelerating or decelerating
This flag indicates when an overflow
or underflow has occurred in the
pulse output 0 PV.
Cleared when operation starts.
OFF: Normal
ON: Overflow or underflow
Settings Status Status
after at star-
mode
change
--- --- Cleared
Cleared
--- --- Cleared
--- --- Cleared
Appendix D
Write Related
timing flags, set-
tup tings
Refreshed ---
each cycle
during
oversee
---
process.
Refreshed
when the
INI(880)
instruction
is executed
(PV
change).
Refreshed ---
each cycle
during
oversee
process.
Cleared ---
when the
PV is
changed
by the
INI(880)
instruction.
Refreshed
when an
overflow or
underflow
occurs.
705