Lcd Option Board Installation And Removing - Omron CP1L-EL20DR-D Operation Manual

Installation and Removing
11-4 Installation and Removing
Installation
!Caution Always turn OFF the power supply to the CPU Unit and wait until all the oper-
1,2,3...
Removing
The following processing explains how to install and remove a LCD Option Board.
ation indicators go out before installing or removing the LCD Option Board.
1. Press the up/down lock levers on both sides of the Option Board slot cover
1 at the same time to unlock the cover, and then pull the cover out.
Check the alignment to make the corner cut of the LCD Option Board fit in
2.
the Option Board slot 1, and firmly press the LCD Option Board in until it
snaps into place.
Operation indicators
LCD Option Board
Switch DipSW4 of the CPU Unit to ON.
3.
Note DipSW4 is OFF at shipment
ON
1 2 3 4 5
DipSW4
Press the up/down lock levers on both sides of the LCD Option Board at the
same time to unlock the Option Board, and then pull it out.
Option Board slot 1
SYSMAC
CP1L
COM 01 03 05 07
NC 00 02 04 06
POWER
RUN
ERR/ALM
INH
LNK/ACT
BKUP
1
00 01 02
ANALOG INPUT
COM(V+)
V1 + V2 + COM
MAC Address:
01234567890A
Corner Cut
ESC
OK
Front
COM 01 03
NC 00 02 04
POWER
ESC
RUN
ERR/ALM
INH
OK
LNK/ACT
BKUP
1
00 01
ANALOG INPUT COM(V+)
V1 + V2 + COM
6
MAC Address:
01234567890A
Press
Lock lever
ESC ESC
OK OK
Lock lever
Press
Section 11-4
09 11 01 03 05 07 09 11
08 10 00 02 04 06 08 10
2
03 04 06 00 01 03 04 06
COM 05 07 COM 02 COM 05 07
Back
05 07 09 11 01 03 05 07 09 11
06 08 10 00 02 04 06 08 10
2
02 03 04 06 00 01 03 04 06
COM 05 07 COM 02 COM 05 07
575