Automatic Transfer From The Memory Cassette At Startup - Omron CP1L-EL20DR-D Operation Manual

Memory Cassette Functions
Automatic Transfer
from the Memory
Cassette at Startup
Note
With just a simple DIP switch setting, data stored in advance in the Memory
Cassette can be automatically read when the power is turned ON, and written
to the corresponding areas in the CPU Unit.
Mount a Memory Card and set DIP switch pin SW2 to ON, and then turn the
power OFF and back ON.
All valid data in the Memory Card will be automatically transferred to the CPU
Unit.
When this function is executed, at least the user program must be stored on
the Memory Cassette.
CP1L-EL/EM CPU Unit
SYSMAC
CP1L
Data in CPU
COM 01 03 05 07 09 11 01 03 05 07 09 11
NC 00 02 04 06 08 10 00 02 04 06 08 10
POWER
Unit
RUN
ERR/ALM
INH
LNK/ACT
BKUP
1 2
00 01 02 03 04 06 00 01 03 04 06
ANALOG INPUT COM(V+) COM 05 07 COM 02 COM 05 07
V1+ V2+ COM
MAC Address: DIP switch SW2 set to ON.
01234567890A
Data automatically transferred from Memory
Cassette to CPU Unit.
Programs, parameters, DM initial values,
comment memory, etc. (Can be specified
individually.)
This function can be used to copy data to another CPU Unit without using the
CX-Programmer.
CP1L-EL/EM CPU Unit
SYSMAC
CP1L
Data in CPU
COM 01 03 05 07 09 11 01 03 05 07 09 11
NC 00 02 04 06 08 10 00 02 04 06 08 10
POWER
Unit
RUN
ERR/ALM
INH
LNK/ACT
BKUP
1 2
00 01 02 03 04 06 00 01 03 04 06
ANALOG INPUT COM(V+) COM 05 07 COM 02 COM 05 07
V1+ V2+ COM
MAC Address:
01234567890A
Programs, parameters, DM initial
values, comment memory, etc.
User programs can be overwritten to upgrade equipment versions without
using the CX-Programmer.
If writing data from the CPU Unit to the Memory Cassette and the CPU Unit is
set to use the operating mode specified in the PLC Setup as the operating
mode after automatic transfer at startup, operation can be started without
cycling the power, enabling operation from the Memory Cassette.
Power turned ON.
SYSMAC
CP1L
CP1W-ME05M
MAC Address:
01234567890A
Memory Cassette
Section 8-6
Another CPU Unit
COM 01 03 05 07 09 11 01 03 05 07 09 11
NC 00 02 04 06 08 10 00 02 04 06 08 10
POWER
RUN
ERR/ALM
INH
LNK/ACT
BKUP
1 2
00 01 02 03 04 06 00 01 03 04 06
ANALOG INPUT COM(V+) COM 05 07 COM 02 COM 05 07
V1+ V2+ COM
Can be automatically
transferred at startup.
437