Connecting To A Serial Port - Omron CP1L-EL20DR-D Operation Manual

Connecting the CX-Programmer
5-1-2

Connecting to a Serial Port

4. Set the target PLC's IP Address.
If do not know the target PLC's IP address, user can click the Browse but-
ton on the right side of IP Address and it will show a dialogue box as follow.
The CX-Programmer will automatically search all CP1L-EL/EM series
PLCs under the same segment in the local area. All PLC found by CX-Pro-
grammer will be listed with the IP address, PLC's type and MAC ID in the
Select Target IP Address dialogue box. Choose a target PLC to be con-
nected and click the OK button.
5. Change the IP setting in PC side to an IP address in same subnet as the
target PLC.
6. Click the OK button in the Network Settings dialogue box and finish the
settings.
7. Then connect to the CP1L-EL/EM by executing the CX-Programmer's on-
line connection command.
Mounting a CP1W-CIF01 RS-232C Option Board in a CP1L-EL/EM Option
Board slot makes it possible to connect Support Software with serial commu-
nications, just as with previous models.
Recommended cable
XW2Z-200S-CV (2 m) or
XW2Z-500S-CV (5 m)
CP1W-CIF01
RS-232C Option Board
Personal computer
CX-One (e.g., CX-Programmer)
D-Sub connector
(9-pin, female)
D-Sub connector
(9-pin, male)
SYSMAC
CP1L
COM 01 03 05 07 09 11 01 03 05 07 09 11
NC 00 02 04 06 08 10 00 02 04 06 08 10
POWER
RUN
ERR/ALM
INH
LNK/ACT
BKUP
1 2
00 01 02 03 04 06 00 01 03 04 06
ANALOG INPUT
COM(V+) COM 05 07 COM 02 COM 05 07
V1+ V2+ COM
MAC Address:
01234567890A
Section 5-1
149