Figure 112. Window For Configuring Local Bridging Forwarding Of Remote Ap Group - Samsung WEC8500 Operation Manual

Configuration using Web UI
In the menu bar of <WEC Main window>, select <Configuration> and then select the
<AP Groups> menu in the sub-menus. After selecting the name of the remote AP group,
you can configure Local Bridging in the "ACL Profile" item of the 'Remote AP Group' tab.
In addition, you can click the "Send To APs" button to send the information on ACL Profile,
Tunnel Forwarding, and Local Bridging Forwarding to APs.
Figure 112. Window for Configuring Local Bridging Forwarding of Remote AP Group
Setup Remote AP Group DHCP
If you assign some AP which is included in Remote AP Group as a DHCP server AP, you
can support DHCP service without another DHCP server.
Support a function to assign a specific IP address at a specific MAC address, or support
an IP address range which will be assigned to DHCP Server and Lease Time.
Configuration using CLI
Execute the following commands to configure Remote AP Group's DHCP.
1
WEC8500# configure terminal
WEC8500/configure#
WEC8500/configure/ap-group [remote-ap-group-name]
WEC8500/configure/ap-group/[remote-ap-group-name]#remote
2
WEC8500/WEC8050 (APC) Operation Manual v10.1
©Samsung Electronics America
of the remote AP group to APs.
Enter configure  Remote AP Group DHCP setup mode using CLI.
Enable/disable DHCP Server AP for using as a DHCP Server.
164