Figure 249.
Station Allowed Limit Configuration Window
Enabling Blocking Function
The setting of enabling the blocking function is as follows:
Configuration using CLI
1
WEC8500# configure terminal
2
WEC8500/configure# wids containment enable
3
Configuration using Web UI
In the menu bar of <WEC Main window>, select <Configuration> and then select
<Wireless Intrusion> <Containment> <General> menus in the sub-menus.
Select Enable and Disable and press Apply to activate and deactivate the wireless
intrusion blocking policy.
Figure 250.
Wireless Intrusion Containment General Configuration Window
Blocking
The W-EP WLAN system performs blocking to the detected AP and the wireless device.
The method for blocking is classified as follows:
WEC8500/WEC8050 (APC) Operation Manual v10.1
©Samsung Electronics America
Go to the configure mode of the CLI.
Enable the blocking function.
To check the configuration information, execute the following command:
o show wids containment current-config
374