Apc Management Port Configuration - Samsung WEC8500 Operation Manual

WEC8500/configure #
Adding or Deleting an Account
The commands used to create or delete an account are as follows:
•
•
WEC8050/configure# mgmt-user test 1 description "test account"
PASSWORD
CONFIRM PASSWORD
USER(test) CREATED.
WEC8050/configure# no mgmt-user test
user(test) deleted.
Retrieving Account Information
To check user account information use the 'show mgmt-users' command.
Changing Password
Use the 'password' command to change the password for your account.
The 'password' command must be executed in the highest user mode.
WEC8500# password
CURRENT PASSWORD
NEW PASSWORD
CONFIRM NEW PASSWORD

APC Management Port Configuration

To connect to the APC remotely using telnet/SSH or web, it is necessary to set up an IP
address to the management port.
Set up the management port as follows:
1
WEC8500# configure terminal
WEC8500/configure# interface mgmt0
2
WEC8500/configure/interface mgmt0# ip address 100.100.100.1/24
WEC8500/WEC8050 (APC) Operation Manual v10.1
©Samsung Electronics America
mgmt-user [USERNAME] [USERLEVEL] description [DESCRIPTION]:
Adds a user
no mgmt-user [USERNAME]: Deletes a user
Parameter
USERNAME
USERLEVEL
DESCRIPTION
: *********
: *********
: ********
: ********
: ********
Go to configure  'mgmt0' interface configuration mode of CLI.
Set up an IP address.
Description
User ID
User level
Adds user information
20