Figure 300.
SNMP Trap Configuration
SNMP v3 User
Using SNMP v3 User configuration, you can assign access rights of read-only or read-
write for each users, and limit configuration rights.
Configuration using CLI
To add SNMP v3 User, execute following command:
1
WEC8500# configure terminal
WEC8500/configure#
2
3
Configuration using Web UI
In the menu bar of <WEC Main window>, select <Administrator> and then select the
<SNMP> <APC> <v3 User> menu in the sub-menus.
Click <Add> button on the v3 User window, then created SNMP v3 User window is
displayed. Input configuration value and click <Apply> button, then it is applied.
WEC8500/WEC8050 (APC) Operation Manual v10.1
©Samsung Electronics America
Enter to configure mode of CLI.
Add SNMP v3 User.
o snmp
user
[USER_NAME]
[AUTH_KEY] [PRIV_PROTOCOL] [PRIV_KEY]
Parameter
USER_NAME
ACCESS
AUTH_PROTOCOL
AUTH_KEY
PRIV_PROTOCOL
PRIV_KEY
You can check created SNMP v3 User by using 'show snmp user'
command.
[ACCESS]
Description
SNMP v3 user name to be added.
Access rights (rw/ro)
• rw: read-write rights
• ro: read-only rights
Authentication Protocol
• MD5: Message-Digest algorithm 5
• SHA: Secure Hash Algorithm
Authentication Key
Privacy Protocol
• DES: Data Encryption Standard
• AES: Advanced Encryption Standard
Privacy Key
[AUTH_PROTOCOL]
438