Enable the operation after authentication and configure <URL>.
For details on <Derivation Profile Name> configuration, see the section on 8.7.2
Derivation Profile Configuration in this document.
Figure 258.
WLAN Web Policy Configuration Window
Configuring Web Authentication on MAC Authentication Failure
To provide the service of Web Authentication on MAC Authentication Failure, the MAC
Authentication of security L2 of the WLAN must be enabled and the web policy of L3 and
the web authentication of the captive portal must be configured.
Configuration using CLI
[WLAN Configuration]
To configure Web Authentication on MAC Authentication Failure in the WLAN, execute
the command as follows:
1
WEC8500# configure terminal
WEC8500/configure# wlan 1
2
WEC8500/configure/wlan 1# security
WEC8500/configure/wlan 1/security# layer3
WEC8500/configure/wlan 1/security/layer3#
3
WEC8500/configure/wlan 1/security/layer3# web-policy macAuthFailure
4
WEC8500/WEC8050 (APC) Operation Manual v10.1
©Samsung Electronics America
Go to configure WLAN configuration mode of CLI.
Go to configure WLAN security layer 3 configuration mode of
CLI.
Enable the WEB authentication (default: disabled).
o web-policy macAuthFailure
Next step, refer to CLI of 8.3.2 Web Authentication.
383