Figure 159. Static Wep Configuration; Dynamic Wep Configuration - Samsung WEC8500 Operation Manual

and go to the <Security>  <L2> tab.
Figure 159. Static WEP Configuration
Select the L2 Security Type as Static WEP. After configuring the rest values as required,
click the <Apply> button.
For more information about detail configuration item of L2 tab, see '5.3.1 Initialization of
WLAN Security Function'.

Dynamic WEP Configuration

The Dynamic WEP is a security algorithm that improves the security vulnerabilities of a
static WEP by using 802.1x authentication. Unlike the static WEP that is based on a
configured fixed key, it creates a cryptographic key by executing 802.1x authentication
when a terminal is connected.
Configuration using CLI
For dynamic WEP configuration, execute the command as follows:
1
WEC8500# configure terminal
WEC8500/configure# wlan 1
2
WEC8500/configure/wlan 1# security
WEC8500/configure/wlan 1/security# setDefault
3
WEC8500/configure/wlan 1/security# ieee8021x
4
WEC8500/configure/wlan 1/security# ieee8021x encryption [KEY_LENGTH]
WEC8500/WEC8050 (APC) Operation Manual v10.1
©Samsung Electronics America
Go to configure  wlan configuration mode of CLI.
Go to security configuration mode and initialize the configuration.
Enable the 802.1x authentication.
To configure the length of a cryptographic key of dynamic WEP, execute
the following command:
230