Configuration Synchronization - Samsung WEC8500 Operation Manual

Configuration Synchronization

For all APCs in an environment configured with multiple APCs to provide the same WLAN
service, all their service-related settings, other than the individual network settings, must
be identical. For this, the system provides a function for automatically synchronizing
service-related configurations across multiple APCs.
When service settings are changed on the master APC, the settings are automatically
applied to the connected slave devices. Service configuration synchronization currently
supports two APCs only.
Configuration Information Synchronization
Configuration using CLI
[Adding APC to APC List]
Add APCs to synchronize to the APC list by referring to 'APC List Management'.
[Adding APC to Sync List]
After adding APCs to the APC list, APCs to synchronize must be added to the Sync List.
1
WEC8500# configure terminal
WEC8500/configure# configuration-sync
WEC8500/configure/configuration-sync#
2
[Deleting APC from Sync List]
Registered APCs can be deleted from the Sync List.
1
WEC8500# configure terminal
WEC8500/configure# configuration-sync
WEC8500/configure/configuration-sync#
2
WEC8500/WEC8050 (APC) Operation Manual v10.1
©Samsung Electronics America
Go to the configure mode of the CLI.
Add APCs to the Sync List.
o add-apc[INDEX][APC_NAME][IP_VERSION][IP_ADDRESS]
Parameter
INDEX
APC_NAME
IP_VERSION
IP_ADDRESS
Go to the configure mode of the CLI.
Delete APCs from the Sync List. To delete all APCs from the Sync List,
enter the 'del-apc-all' command.
o del-apc [INDEX]
o del-apc-all
Description
INDEX on the Sync List (range: 1-2)
APC name (maximum 18 characters)
Ipv4/ipv6
Ipv4 or Ipv6 address
476