Figure 111. Window For Configuring Tunneling Forwarding Of Remote Ap Group - Samsung WEC8500 Operation Manual

Figure 111. Window for Configuring Tunnelling Forwarding of Remote AP Group
Configuring Local Bridging Forwarding of Remote AP Group
You can configure the VLAN ID, ACL, and PreAuth ACL to a WLAN set with local bridging
among WLANs included in the remote AP group.
Configuration using CLI
To configure the local bridging forwarding of the remote AP group, perform the command
as follows:
1
WEC8500# configure terminal
WEC8500/configure#
WEC8500/configure/ap-group [remote-ap-group-name]
WEC8500/configure/ap-group/[remote-ap-group-name]#remote
2
3
4
5
WEC8500/WEC8050 (APC) Operation Manual v10.1
©Samsung Electronics America
Go to configure  Remote AP Group configuration mode of CLI.
Configure the information on Local Bridging to the WLAN set with the
tunnelling mode.
o local-bridging [WLAN-ID] { vlan-id [VLAN-ID] | acl-name [ACL-NAME]
| pre-auth-name [PRE-AUTH-NAME] }
Execute the 'show ap-group remote-forwarding [REMOTE AP GROUP
NAME]' command to check the AP group information.
Use the 'send-remote-acl-to-ap profile-only' command to send the ACL
Profile information of the remote AP group to APs.
Use the 'send-remote-acl-to-ap all' command to send the information on
the ACL Profile, Tunnelling Forwarding and Local Bridging Forwarding
163