Samsung WEC8500 Operation Manual page 175

4
Configuring IoT Controlling Service of AP Group with CLI
1
WEC8500# configure terminal
WEC8500/configure#
2
3
4
WEC8500/WEC8050 (APC) Operation Manual v10.1
©Samsung Electronics America
Configure the IPSec function for the AP group.
o overwrite-ip-sec
o enable
o primary-ip
o right-subnet
o right-subnet-mask
o ike-version
o ike-lifetime
o ipsec-lifetime
Parameter
OVERWRITE-IP-SEC
ENABLE
PRIMARY-IP
RIGHT-SUBNET
RIGHT-SUBNET-MASK
IKE-VERSION
IKE-LIFETIME
IPSEC-LIFETIME
Go to the configure mode of the CLI.
Create an AP group or enter the AP group configuration mode.
ap-group[AP_GROUP_NAME]
Enter the Iot controller configuration mode for the AP group.
o Iot-controller
Configure the Iot controller function for the AP group.
o overwrite-flag
o enable
o controller-v4-address
o controller-port
o life-time
Parameter
OVERWRITE-FLAG
ENABLE
Description
If overwrite-ip-sec is enabled, the ip-sec information set
for the AP group is applied to all APs within the group.
Enables/disables the IPSec function.
Configures the address of the primary security gateway.
Configures the address of the traffic selector for IPSec.
Configures subnet mask of the traffic selector for IPSec.
Configures the IKE version.
1/2
Configures the IKE SA validity. (Unit: hours)
Configures the IPSec SA validity. (Unit: minutes)
Description
If overwrite-flag is enabled, the IoT-controller information
set for the AP group is applied to all APs within the group.
Enables/disables the IoT controller function.
156