Location Tracking
The APC tracks the location information of several terminals in a wireless LAN network
based on the wireless data collected from W-EP wireless LAN APs.
To configure the location tracking function, execute the command as follows:
Configures Location Tracking
1
WEC8500# configure terminal
WEC8500/configure # locationtrack
WEC8500/configure/locationtrack #
2
WEC8500/configure/locationtrack # enable
Configures Location Tracking Scan
1
2
3
WEC8500/WEC8050 (APC) Operation Manual v10.1
©Samsung Electronics America
Go to configure locationtrack configuration mode of CLI.
Configure the location tracking function.
When applying the location tracking scan information to the APC, the
method varies according to type. A method of applying the scan
information can be selected using the following command:
o scan-result-type[TYPE]
Parameter
TYPE
The maximum number of APs belonging to the APC, which is to be
applied with the location tracking scan information, can be specified
using the following command:
o num-req-ap-list[NUM]
Parameter
NUM
The scanning interval for location tracking can be configured using the
following command:
o scan-report-intv[NUM]
Description
• 0: Applies scan information to all channels
• 1: Applies AP information using the same SSID
• 2: Transmits the previously scanned information first
and then applies the scan information to all channels
• 3: Transmits the previously scanned information first
and then applies the AP information using the same
SSID
• 4: Transmits the previously scanned information only
Description
NUM (range: 1-500)
306