Figure 151. Local Switching Configuration Window Of Wlan - Samsung WEC8500 Operation Manual

ME
4
Configuration using Web UI
By referring to the 'Configuring Remote AP Group', add an AP to a remote AP group.
In the menu bar of <WEC Main window>, select <Configuration> and then select the
<WLANs> menu in the sub-menus. Select a WLAN ID to change in the WLANs screen
and go to the <General> tab. After changing the 'CAPWAP TUNNEL MODE' to 'Local
Bridging', click the <Apply> button.
Figure 151. Local Switching Configuration Window of WLAN
In the menu bar of <WEC Main window>, select <Configuration> and then select the
<Access Points> menu in the sub-menus. In the Access Points screen, select an AP to
change and go to the <Remote AP> tab.
Select the WLAN set with tunnelling and enter the split ACL before clicking the <Add>
button.
WEC8500/WEC8050 (APC) Operation Manual v10.1
©Samsung Electronics America
Parameter
WLAN_ID
VLAN_ID
ACL_NAME
PRE_AUTH_ACL_NA
Operator can check the configuration information by executing the 'show
remote-ap-group summary', 'show wlan detail', 'show ap local-bridging
[AP_PROFILE_ NAME]' command.
Description
WLAN ID (Range: 1-254)
(available only for WLANs the tunnel-mode of which is local-
bridging)
VLAN ID (Range: 1-4094)
ACL name to configure for the WLAN service
(only for options set in IP ACL)
ACL name to configure for pre-authentication of the WLAN
(only for options set in IP ACL)
217