Samsung WEC8500 Operation Manual page 189

Configuration using Web UI
In the menu bar of <WEC Main window>, select <Configuration> and then select the
<AP Groups> menu in the sub-menus. After selecting the name of a Mesh AP group, you
can configure additional functons in item of the 'Mesh' tab.
Configure Monitoring Function for Mesh AP Group
APC Operator can configure monitoring function on Mesh AP group.
In the menu bar of <WEC Main window>, select <Monitor> and then select the <Access
Points > menu in the sub-menus. You can monitor Mesh AP status.
Configuration using CLI
To configure monitoring function on Mesh AP group, execute the command as follows:
1
WEC8500# configure terminal
WEC8500/configure#
WEC8500/configure/ap-group {mesh-ap-group-name}
WEC8500/configure/ap-group/{mesh-ap-group-name}# mesh
2
3
WEC8500/WEC8050 (APC) Operation Manual v10.1
©Samsung Electronics America
Go to the configure  Mesh AP Group mode of the CLI.
Configure function enable, active RSSI threshold, alarm enable of
Neighbour AP, RSSI threshold of Neighbour AP.
o monitoring use [enable/disable]
o monitoring active-rssi-threshold [THRESHOLD_VALUE]
o monitoring neighbor-ap-alarm [enable/disable]
o monitoring neighbor-rssi-threshold [THRESHOLD_VALUE]
Execute the 'show ap-group mesh monitor-config [MESH AP GROUP
NAME]' command to check the Mesh AP group monitoring information.
170