Chapter 5 Wlan Management - Samsung WEC8500 Operation Manual

Chapter 5
This chapter describes how to create and configure WLAN that is the most fundamental
basis for W-EP wireless LAN service.
WLAN Configuration
Basic WLAN Configuration
The WLAN profile helps configure and manage the WLAN connection service of an AP in
the APC. To use WLAN service, it is necessary to basically configure AP group and
interface group and specify Service Set Identifier (SSID).
Configuration using CLI
Go to the wlan configuration mode from the configure mode of CLI.
WEC8500# configure terminal
WEC8500/configure# wlan [WLAN ID]
The WLAN configuration procedures are as follows:
WEC8500# configure terminal
WEC8500/configure# wlan 1
WEC8500/configure/wlan 1#
WEC8500# configure terminal
WEC8500/configure# ap-group apg_01
WEC8500/configure/ap-group apg_01# add-wlan 1
WEC8500/WEC8050 (APC) Operation Manual v10.1
©Samsung Electronics America
WLAN Management
Parameter
WLAN_ID
Go to configure  wlan configuration mode of CLI.
1
2 Add WLAN to an AP group.
Configure an AP group to which WLAN service will be provided. The AP
group configuration is only possible in the AP group configuration mode
instead of the wlan configuration mode. The below configuration
allocates wlan 1 to the apg_01 AP group.
A newly created WLAN is added to the 'default' AP group if the WLAN ID is
in the range of 1-16. If the WLAN ID is 17 or above, the WLAN is not included
in the AP group.
Maximum 16 WLANs can be allocated to each AP group.
3 Configure an interface group to which the WLAN service will be provided.
Description
WLAN ID (range: 1-255)
202