Ipv6 Station; Figure 91. Widow For Enabling Or Disabling Ipv6 Station Service - Samsung WEC8500 Operation Manual

IPv6 Station

This configuration can control the WLAN service for IPv6 stations and provide the ability
to check whether the IPv6 address of the stations which is connected to the WLAN is valid.
Configuration using CLI
1
WEC8500/configure# [no] ipv6 station enable
2
WEC8500/configure# [no] ipv6 station valid-check
3
WEC8500# show ipv6 station config
Address Valid Check ... Disabled
Mode .................. Enabled
Configuration using Web UI
Select the <CONFIGURATION> in the menu bar of the <WEC Main Window> and then
the <CONTROLLER>  <General> in the sub-menu of the <CONFIGURATION>.
Enable or disable IPv6 station service.
Figure 91. Widow for enabling or disabling IPv6 Station Service
WEC8500/WEC8050 (APC) Operation Manual v10.1
©Samsung Electronics America
Inactivate or enable WLAN service to the IPv6 stations. A reconnection
is required because a station is kicked out after the configuration
changes.
Enable or disable the function of checking if the address of an IPv6
station is valid in a WLAN each time the station is connected to the
WLAN. This function can only be set to CLI.
The setting information can be found below.
126