Policy-Map Configuration - Samsung WEC8500 Operation Manual

5
6

Policy-map Configuration

1
APC# configure terminal
APC/configure# fqm-mode
2
3
4
WEC8500/WEC8050 (APC) Operation Manual v10.1
©Samsung Electronics America
Match Criteria
access-group
class
COS
destination IP range
IP
protocol
source IP range
Exit the Class-map mode.
o exit
To check the configuration information, use the 'show running-config
network' command.
Go to the fqm mode to configure the configure  ACL rule of CLI.
Go to policy-map mode. To delete a policy map, enter 'no' parameter in
front of the command.
o policy-map [POLICY_MAP_NAME]
o no policy-map [POLICY_MAP_NAME]
By using the class name configured in the class-map, go to the input
mode.
o class [CLASSMAP_NAME]
Configure a policy-map using the following command:
[Bandwidth to a class of traffic]
o bandwidth percentage [PERCENTAGE_VALUE]
[Configure set action]
o mark cos [COS_VALUE]
o mark ip dscp [DSCP_VALUE]
o mark ip precedence [PRECEDENCE_VALUE]
o mark priority [PRIORITY_VALUE]
[Configure police action]
o police trtcm cir [1-1000] cbs [125000-125000000] pir [1-1000] pbs
[125000-125000000]
7])|transmit) exceed-action (drop|(dscp [0-63]|ip [0-7])|transmit)
Description
match access-group [ACCESS_GROUP_NAME]
match class [CLASS_NAME]
match cos [COS_VALUE/any]
match dst ip range [A.B.C.D] [A.B.C.D]
match ip dscp [DSCP_VALUE/any]
match ip precedence [IP_PRECEDENCE_VALUE/any]
match ip tos [TOS_VALUE/any]
match protocol [PROTOCOL_VALE/any]
match src ip range [A.B.C.D] [A.B.C.D]
conform-action (drop|(dscp [0-63]|ip [0-
100