Samsung WEC8500 Operation Manual page 210

[max-download]
This command configures the maximum number of simultaneous downloads when
transmitting the package file of an AP from the APC to the AP.
•
[max-retry]
This command configures maximum number of re-attempts when AP upgrade is failed.
•
[start]
This command provides the entire AP upgrade function.
•
If you perform package upgrade after configuring AP upgrade type to predownload,
restart all the APs in the following methods:
WEC8500# configure terminal
WEC8500/configure# ap-all
WEC8500/configure/ap-all# reboot upgrade
[stop]
This command provides the function of stopping the image upgrade of all the APs.
•
[show ap upgrade]
To check the upgrade information of an AP, use the following command:
WEC8500/WEC8050 (APC) Operation Manual v10.1
©Samsung Electronics America
Parameter
TRANSFER_MODE
Max-download [COUNT]
Parameter
COUNT
Max-retry [COUNT]
Parameter
COUNT
start [UPGRADE_TYPE]
Parameter
UPGRADE_TYPE
stop
Description
File transmission protocol (ftp/sftp)
• ftp: ftp is used for file transmission.
• sftp: sftp is used for file transmission.
Description
Maximum number of simultaneous downloads of AP image
file (range: 1-50, default: 10)
Description
Maximum number of AP upgrade re-attempts (range: 1-10,
default: 3)
Description
Configures upgrade type (quick-upgrade/predownload)
• quick-upgrade: Perform entire ap upgrade upon an
operator's request.
• predownload: Download ap image to ap first during entire ap
upgrade.
191