Ip Multicast Routing Configuration; Pim Configuration; Ospf Configuration - Samsung WEC8500 Operation Manual

Static Route window. If the added information is not displayed, it means the added routing
information is not enabled. If the operational status of an interface that will be used as a
routing result is not UP, check the interface status through CLI or Web UI.
Because only enabled routing entries are listed in the Web UI, you cannot remove a
disabled routing entry.

IP Multicast Routing Configuration

3
WEC8500# configure terminal
WEC8500/configure#
1
2

PIM Configuration

The procedure for Protocol Independent Multicast (PIM) configuration is given below:
1
WEC8500# configure terminal
WEC8500/configure# interface ge2
2
WEC8500/configure/interface ge2# ip pim sparse-mode
3
WEC8500# show ip mroute
(90.90.1.242, 224.0.1.1)

OSPF Configuration

General Settings
Configuration using CLI
1
WEC8500# configure terminal
WEC8500/configure# router ospf
WEC8500/WEC8050 (APC) Operation Manual v10.1
©Samsung Electronics America
Go to the configure mode of the CLI.
Enable or disable multicast-routing.
o ip multicast-routing
o no multicast-routing
Check multicast-routing using the 'show running-config network'
command.
Go to configure  interface configuration mode of CLI.
Configure the PIM sparse mode to an interface.
Check a configured PIM using the 'show running-config network'
command.
To check the multicast-routing table, use the 'show ip mroute' command.
Iif: mgmt0
Go to configure  ospf configuration mode of CLI.
Oifs: pimreg
61